First, the food / beverage clean room preferably with the outside world, can not walk through or interference by other factors, the size of the food clean room as needed, generally from the locker room, buffer room between Airshower and an action, dressing room on the outside, mainly for the replacement of the hat, shoes, etc., located between the buffer between the air shower and locker room, but also between several operations at the same time and the same, the operating room in each room, mainly for products filling the room should be free from direct sunlight, appropriate size, height suitable (specific height determined in accordance with the production equipment), the room is too large, sweeping and disinfection inconvenience is too small, inconvenient operation, the top is too high will affect the effective UV sterilization effect, Wall provision no dead ends should be smooth so that cleaning and disinfection, food clean room should be sealed and kept a positive pressure differential static pressure workshop, set air disinfection with ultraviolet light, the air filter purifiers and thermostat. Second, the building layout Description: Construction plane setting should belong to the architectural profession professional context, but because the food clean room requirements, was split, and to keep the static pressure gradient between the various clean operation, therefore, the project requires the building plan The following points. 1, the focus is set between the cleanup operation is independent of the front compartment of the airlock between the gas chamber in communication with the operations simultaneously, ensure that the air is not clean area low to high penetration of clean areas. 2, the flow of people through the locker room replace laboratory clothing and shoes, wash their hands clean room, buffer room, air shower, each operating room. 3, food clean room logistics corridor through mechanical linkage from the outside from entering the buffer disinfection sterilization transfer window transfer window into the hallway and then through each operating room. Third, the structure according to the workshop on "clean plant design specifications" workshop walls and ceiling must not produce dust, no dust smooth surface material of construction, and the dead can not exist in the workshop, using special color plates purification plant construction, To improve the purification plant life and achieve beautiful results, all aluminum material to choose good. Fourth, on the ground floor shop using solvent-based epoxy resin, dense surface, free from sand, hollowing, cracks, bright colors, anti-static performance constancy, can withstand moderate the following load, high temperature, on the basis of meet on, it can play a decorative role, wear, abrasion, dust, non-slip, excellent performance, uniform color and gloss. Fifth, the ventilation air purification equipment: clean room design, in accordance with regulatory requirements, design a return air system, the engine room is located in the top side of the plant conditions on the ground, can be modular purification system, do not set up the room, each return air circulation wind pipe in the technical mezzanine connected air conditioning unit as a system, return air duct made of high quality galvanized steel, the damper flexible connection, galvanized steel duct on-site production. Sixth, the lighting should be used to clean areas purify ceiling lamps, non-clean areas use ordinary fluorescent lamps, lighting design in each room, independent control of UV light, and by the electrical control box, and then by the total distribution cabinet centralized control, interior lighting are used in confined lighting group, socket plates are embedded, the room is not open wire laying. http://www.zzhyjh.com decontamination, purification color plate, clean air-conditioning, clean room clean, ventilation ducts